Mount long tools where your vehicle has usable bar space. This two-piece universal gun holders attaches to compatible round or square bars, giving ATV and UTV owners adjustable, padded grips for work and outdoor gear.
Why You’ll Love These Adjustable Gun Holders
- Place the two holders at the spacing your equipment needs.
- Rotate the grips to adjust the carrying angle.
- Rubber straps add retention around each item.
- EVA pads cushion the contact points and help reduce vibration.
- Remove or reposition the holders when your storage needs change.
Best For Riders Who
- Have a suitable ATV or UTV roll bar, rack, or bumper guard.
- Carry tools such as shovels, rakes, fishing rods, or other long equipment.
- Want to choose their own mounting position.
- Need two separate holders rather than a vehicle-specific under-seat rack.
Fitment
Compatible with the following vehicles:
- ATVs, UTVs, hunting bikes, tool strollers, snowmobiles, golf carts, scooters, trucks, marine boats, yachts and RVs for securing your tools
- Fits vehicles with dia. of 0.9-2" (Round), 0.6-1.7" (Square), up to 1.5" (drillable flat surfaces).
- Fits tools with 4 in dia.
-
Mountable on overhead/slated/front/side/rear roll bar, bumper guard, etc.
Material & Protection
Material
- Two reinforced-nylon holders.
- Soft EVA grip pads and rubber retaining straps.
- Mounting hardware for compatible vehicle attachment points.
Protection
- EVA pads cushion gear and help reduce vibration at the contact points.
- Rubber straps add retention when traveling over uneven ground.
- Keeping long items in designated holders helps reduce contact with other equipment.
Design & Fit
- Holders tilt up to 180° to adjust the carrying angle.
- Mounts to square bars measuring approximately 0.6–1.68 inches or round bars measuring 0.9–2 inches in diameter.
- The listing also describes mounting to suitable flat surfaces up to 1.5 inches thick.
- A 15 kg (approximately 33 lb) load rating is listed, but the source does not clarify whether it applies to one holder or the pair.
Installation
- Measure the intended bar or flat mounting surface before installation.
- Position the two holders at the spacing needed for your equipment and secure them with the supplied hardware.
- Check fasteners, grip angle, and strap tension before use.
FAQs
Q1: Will these holders fit my ATV or UTV?
A1: Fit depends on the mounting point’s shape and measurements. Compare your bar or flat surface with the ranges in the Fitment tab.
Q2: How does the quick-release clamp work?
A2: The clamp comes with quicj-release knob to release the clamp and base, allows fast installation and removal without needing to permanently modify your vehicle or pulling/pushing with much efforts.
Q3: Can I change the grip angle?
A3: Yes. The holder angle is adjustable, with up to 180° of tilt stated in the listing.
Q4: Will the grips scratch my tools?
A4: EVA pads help cushion contact, though dirt trapped between a tool and the pads can still cause marks. Keep the contact surfaces clean.
Q5: Can I move the rack between vehicles?
A5: Yes. The 4-screw design makes it convenient to transfer between compatible ATVs, UTVs and other vehicles with suitable mounting tubes.
Installation Guide
Installation Instructions: Installation instructions are included in the package.