ABG242-UTV
UForce 600 back windshield
10% OFF For First Order: SK10 copy

CFMOTO UForce 600 tinted polycarbonate rear windshield to maintain an ultra-clear, glare-free rearview during daily ranch work or rugged off-road exploration. Deflect heavy rain, swirling trail dust, and back-draft winds.
Why You’ll Love UForce 600 Rear Windshield
Best For Riders Who
Compares
| Feature | StarknightMT Rear Windshield | Without Windshields |
|---|---|---|
| Dust | Zero Dust Back-Sucking | Heavy Dust Influx |
| Glare & UV Protection | Blocks blinding rear glare and harsh UV rays | Blinding Glare & Sun Fading |
| Noise | Quieter Driving Environment | Deafening Wind Noise |
Compatible with the following vehicles
Compatibility note
Material
Protection
Installation
Q1: Can it be installed without tools?
A1: The StarknightMT Uforce 600 Rear Windshield can be installed without drilling—it comes with pre-drilled installation holes and all necessary hardware.
Q2: Is it compatible with the UForce 800XL?
A2: It is compatible, but the rear windshield requires additional drilling to fit the UForce 800XL.
Q3: Does the gray tint on the rear windshield reduce driving visibility?
A3: It has a stronger and high light transmission, which can be equipped with a rearview mirror for use, and enjoy a clear view of the rear of the car.
No, the StarknightMT's Uforce 600 rear windshield is a full back windshield design. It can protect against tough weather conditions and stop unwanted elements from flying into your cab.
The Uforce 600 back windshield is made of premium polycarbonate that is 25 times tougher than acrylic and 250 times stronger than glass. Also, it has a stronger and higher light transmission.
First, install the rubber seals. Second, install the two lower panel brackets, and then tighten the other six screw kits. More detailed instruction is included.
It fits great and once you figure out how it goes on its pretty easy. Also makes it quieter inside the machine.
Followed instructions, relatively easy install with two persons. Fit perfectly, I did not place gasket seam on the corner as instructions showed. I placed it in the center of the bottom of the windshield. Seemed more appropriate and less likely to cause future issues. Not much information given on tightening method, caution be careful not to over tighten
Installed this in a 2025 Uforce 600. It took about a half hour for my father and I to install it. Highly recommended
The rear windshield arrived packaged well and all the needed parts were bagged. The instructions are just okay- had to watch a couple YouTube videos to familiarize myself with the install. Once installed, it looks good and keeps the backdraft out.
I get two thirds of the way when I realized I was missing the number 8 washers I am assuming that they are nylon because metal will wear the windshield.